ISPRS Ann. Photogramm. Remote Sens. Spatial Inf. Sci., II-5, 379-384, 2014
http://www.isprs-ann-photogramm-remote-sens-spatial-inf-sci.net/II-5/379/2014/
doi:10.5194/isprsannals-II-5-379-2014
© Author(s) 2014. This work is distributed
under the Creative Commons Attribution 3.0 License.
 
28 May 2014
How to decide which oblique image has the highest mapping potential for monoplotting method: a case studies on river erosion and floods
M. Triglav-Čekada1, V. Bric1, and M. Zorn2 1Geodetic institute of Slovenia, Jamova cesta 2, 1000 Ljubljana, Slovenia
2Anton Melik Geographical Institute, Scientific Research Centre of the Slovenian Academy of Sciences and Arts, Gosposka ulica 13, 1000 Ljubljana, Slovenia
Keywords: Monoplotting, interactive orientation of images, oblique images, digital elevation models, lidar Abstract. When studying the development of different geomorphic processes, floods, glaciers or even cultural heritage through time, one cannot rely only on regular photogrammetrical procedures and metrical images. In a majority of cases the only available images are the archive images with unknown parameters of interior orientation showing the object of interest in oblique view. With the help of modern high resolution digital elevation models derived from aerial or terrestrial laser scanning (lidar) or from photogrammetric stereo-images by automatic image-matching techniques even single nonmetric high or low oblique image from the past can be applied in the monoplotting procedure to enable 3D-data extraction of changes through time. The first step of the monoplotting procedure is the orientation of an image in the space by the help of digital elevation model (DEM). When using oblique images tie points between an image and DEM are usually too sparse to enable automatic exterior orientation, still the manual interactive orientation using common features can resolve such shortages. The manual interactive orientation can be very time consuming. Therefore, before the start of the manual interactive orientation one should be certain if one can expect useful results from the chosen image. But how to decide which image has the highest mapping potential before we introduce a certain oblique image in orientation procedure? The test examples presented in this paper enable guidance for the use of monoplotting method for different geoscience applications. The most important factors are the resolution of digital elevation model (the best are the lidar derived ones), the presence of appropriate common features and the incidence angle of the oblique images (low oblique images or almost vertical aerial images are better). First the very oblique example of riverbank erosion on Dragonja river, Slovenija, is presented. Than the test example of September 2010 floods on Ljubljana moor is discussed. Finally, case study from November 2012 floods is presented. During November 2012 floods an initiative was launched to gather as much non-metrical images of floods as possible from casual observers (volunteered image gathering). From all gathered images the guidelines presented before helped to pick out 21% images which were used for monoplotting.
Conference paper (PDF, 927 KB)


Citation: Triglav-Čekada, M., Bric, V., and Zorn, M.: How to decide which oblique image has the highest mapping potential for monoplotting method: a case studies on river erosion and floods, ISPRS Ann. Photogramm. Remote Sens. Spatial Inf. Sci., II-5, 379-384, doi:10.5194/isprsannals-II-5-379-2014, 2014.

BibTeX EndNote Reference Manager XML